24 SeaBird For Sale



 


Specifications

YEAR 1969 BEAM
MAKE SeaBird ENGINE MODEL OMC 350
MODEL Cuddy HORSE POWER
PRICE $4000/ OBO ENGINE HOURS 75
LOCATION SAN DIEGO FUEL GAS
PHONE 760-489-8579 CRUISING SPEED
LENGTH MAX SPEED
LOA 24' FUEL (GALLONS)


 
 

 



Description

24' Seabird CuddyCabin
New- Complete rebuild 350 OMC motor .
All new parts installed with less than 75 hours on Motor
OMC 225 Outdrive gone thru , Have another rebuilt 225 OD paid for but
not installed , Buyer can track it down and put it on New Carberator
New Direct pickup water Pump Risers and Manifolds new All new Hoses
2 new batteries new 2500 GPH Bilge Pump
New Bait Pump 750 to 800 GPH with thru Hull Pickup
New 1 Scoop Bait Bag with 2 smaller baitTanks built into top of Transom
all with control valves
2 New 30inch pedastal seats with cusions
New Bimini Top
New Steering Cable
Newer - 50 gallon fuel tank
New deck put down
Full Electronics - Gps , Fishfinder , Vhf Radio , Stereo

 

This Boat has the Largest Cockpit for fishing I have ever seen on a 24' boat .
The Cuddy is way Foreward so there is almost 16' of fishing room in the back
of the boat . 4 people could comfortably fish and 5 wouldn't be crowded .
The entire bottom of the Hull has been reglassed . All 8 chines have been built
up with 4 to 6 layers of fiberglass and WestSystem Epoxy Resin .

 

This Added about a 1/4 inch of thickness to them for structural integrity .
All fiberglass work has been sanded out . All dings and scrapes in the hull
have been Sealed with Epoxy and some filled in completely . Finish her off a
save big $ .

Finish sanding the hull and Paint Boat Take up section of deck in the
helm area and rebuild / repair stringers and Bulkheads Repair some Rott in
Cuddy bench seat Right side Install 2nd fuel tank while Deck is open along
with adding fish Holds

There's ton of room below deck I have lots of material and parts that goes
with boat that's for finishing her out . I believe I have 3 spare props ,
FRP board for use with the project , some more resin , fiberglass ect

 

Trailer is old 1/2 inch thick steel Dual axle EasyLoad . She needs help but still
Towable . Registered forever . I would pick up a good used trailer with bunkers .
I missed one this year for $600 I don't think I would put it back under the boat
after she's painted . The rollers scuff her up to much I've done the hard part .

 

With a little more hard work and not much more money you can have an
excellent fishing boat . For under 6500,00 total cost , you'll have a New kick
asse boat the Tuna will fear .

 

Price $4000.00 OBO Just make me an offer . I've got to get her out of here .
I can't take listening to the Misses anymore

Home - 760-489-8579 Cell 760-807-4871 Michael